/
Configuring Toshiba Pro Print for Apple Devices

Configuring Toshiba Pro Print for Apple Devices

Owned by Ben Harris
Last updated: Sept 11, 2024
3 min read

The Toshiba Pro Print queue is for Apple devices to be able to print to Toshiba printers using options such as tray selection, hole punching, collating and stapling.

Step 1

Step 2

Step 3

 

 

Restart your device. You must restart your device for the printer queue to be installed. This is an automated configuration change that is managed by our systems and it is a step that can not be skipped.

Ensure you are connected to ECSecure WiFi when the device boots back up.

 

Step1-20240911-124700.png
Select the magnifying glass icon in the top right of your screen.

 

 

 

 

Step2-20240911-123219.png
Type in “printer” and select “Printers & Scanners”

 

Step 4

Step 5

Step 6

 

Step3-20240911-124759.png
You should see “Toshiba Pro Print” as a printer option. If not, please restart your device. Select the arrow icon next to “Toshiba Pro Print”

 

 

Step4-20240911-124832.png
Select “Options & Supplies”

 

 

 

Step5-20240911-124913.png
Select the “Options” tab at the top and fill out the following information. Select OK when done. If you are attempting to use a printer capable of booklet creation, please see the “Booklet Printer Configurations” step below. If there is an option greyed out, ensure you selected the correct Model.

 

Step 7

Step 8

Step 9

 

Step6-20240911-155651.png
Select a test document to print. Ensure you select “Toshiba Pro Print” as the printer and select “Print”

 

 

Step7-20240911-155826.png
In the bottom right hand corner there will be a printer icon with a red number, Select this icon to open the printer queue.

 

 

 

Step8-20240911-155943.png
Your queue will show your print job and it should state “Hold for Authentication”. On the far right side, select the circular arrow icon with a lock in the middle. PLEASE NOTE THE NEXT STEP CAREFULLY.

Step 10

Step 11

Booklet Printer Configurations

 

Step9-20240911-160125.png
When prompted. Erase the name and password. Please enter your Earlham username/password. This is the same username/password you would use for theHeart or your Zimbra email. Select the checkbox “Remember this password in my keychain”. Doing this step incorrectly will cause the print jobs to not show up in your queue at the printer.

 

 

You should now be able to proceed to release your jobs as if you were using regular “Follow Me” printing.

 

Booklet Printer Configuration-20240911-160621.png
This is the Booklet Printer Configuration. Please select the finisher 2 Tray +1 Fixed Tray. Once selected you can then change the correct printer model and Saddle Stitch Finisher.

The 2 Locations capable of Booklet Printing are:

  • Runyan Basement near Post Office

  • Tyler Hall Basement in Kitchen Area.

 

Related content